QUESTIONS & ANSWERS from "Ask-the-Wizard":

ANSWER:

jefrimmer:

As you may know, since the GFI is "popping" nearby, these plugs are most likely on the same circuit, and there is something shorting out the circuit. It could be the switch, it could be the plug, or something could be shorting the wires in this circuit inside your walls (a nail, mice chewing on the wires, etc.).

You want to be very careful with this. The GFI (ground fault interrupter) is there for a reason, to protect your house from short circuits, especially in areas where there could be water that could conduct electricity to a person, for example in bathrooms, kitchens, and exterior locations.

I would think you would want to call in a qualified electrician to inspect your plugs and wiring.

And in the meantime, if you can, to be safe you should consider turning off the breaker at your fusebox, if there is a separate breaker for this circuit.

Hope this is helpful.
Home-Wizard.com
____________________

QUESTION from "Donna": 

Our GFI keeps popping when we run the dishwasher - but we've had it for 8 years and have not relocated any other items.  It won't pop if we run on a low energy cycle - but if we run it on normal it pops.

ANSWER:

Donna:

Regarding your GFI tripping off when you run your dishwasher on its normal energy cycle but not on the low energy cycle, it could be a couple of things happening:

1) as GFIs ("ground fault interrupters") get older over time, they sometimes begin to trip at lower power levels. So in other words, it may have been fine operating at let's say 20 amps for years, but now it trips at 18 amps as the GFI has worn out.

2) Your dishwasher may be exeriencing a power surge when the heater for your dishwasher's normal power kicks on, and this is what is tripping your GFI.

Either way, you probably want a qualified electrician to test your GFI and dishwasher.

Hope this is helpful.
Home-Wizard.com
____________________

QUESTION from "joel.schacter": 

Our GFI keeps popping when we run the dishwasher - but we've had it for 8 years and have not relocated any other items.  It won't pop if we run on a low energy cycle - but if we run it on normal it pops.

ANSWER:

Dear joel.schacter:

As you may know, since the GFI is "popping" nearby, these plugs are most likely on the same circuit, and there is something shorting out the circuit. It could be the switch, it could be the plug, or something could be shorting the wires in this circuit inside your walls (a nail, mice chewing on the wires, etc.).

You want to be very careful with this. The GFI (ground fault interrupter) is there for a reason, to protect your house from short circuits, especially in areas where there could be water that could conduct electricity to a person, for example in bathrooms, kitchens, and exterior locations.

I would think you would want to call in a qualified electrician to inspect your plugs and wiring.

And in the meantime, if you can, to be safe you should consider turning off the breaker at your fusebox, if there is a separate breaker for this circuit.

Hope this is helpful.
Home-Wizard.com
____________________

QUESTION from Vic on 4/3/2008:

If a multitester switch is set to the 15-volt position and the meter pointer indicates a reading of 82 volts on the 150 VOLTS scale, what is the actual voltage being measured?

ANSWER FROM HOME-WIZARD.COM ON 4/3/2008

Dear Vic:

Here is a link to a webpage that describes how to use a multitester, and what the different scales are for:

http://www.do-it-yourself-washing-machine-and-dryer-repair-help.com/how-to-use-a-multitester.html

Hope this is helpful.
Home-Wizard.com
____________________